Aller au contenu

Question chargeur


Kingpolaris

Publications recommandés

il y a 36 minutes, Kingpolaris a dit :

Ton bateau ?

non , le mien est différent , tout est a l'arriere . j'ai aménagé l'espace pour  trois batt 31 et le réservoir d'huile mais j'aimerait une ''house batt'' pour les sonars mais manque de place .

La solution ??  une lithium 24V grosseur 31 pour le minnkota qui laisserait une place pour une 31 lithium pour les sonars .

Je ne suis pas encore décidé d'essayer ca !

Aussi possible de fermer  le trou pour ajouter une batterie et lithium serait plus léger .

20170423_144713.thumb.jpg.9573cf9605268213d13d1693534a121a.jpg

20170428_172647.thumb.jpg.7eca9e0a69e51db6d7fad17424accae9.jpg

20210810_175250 (3).jpg

Modifié par danlaboucane
  • Like 4
Lien vers le commentaire
Partager sur d’autres sites

Batterie au lithium, c'est recommandé de charger à ½C donc le C=100Ampères, 50 ampères max. pour charger.

J'ai lu ceci:

Christopher Tocci

, former Owner-President (now retired) at ALFA Engineering Design (1996-2020)

Theoretically, yes, but practically NO unless you want a bad day near the battery or device you are charging.

Charging is predicated on current with resultant voltage as a secondary consideration with respect to (let’s say) the battery. Once the charge has cause a voltage potential to rise to some level, a circuit will shutdown the charging process and then “trickle” a small current in an ON-OFF basis to maintain a given voltage across the battery.

If you connect two such systems in parallel, ideally both will send positive current into the battery without regard to each other. Reason is two current sources can be connected in parallel with no problems. The charging current does double and cuts your waiting time in half. However, once that battery is charged up to full charge, both chargers change their behavior and begin to look like two voltage sources looking at each other which is not cool. Once this happens, it is quite possible that you could damage one or both chargers and or even the battery. Remember: You can add voltages in series and currents in parallel, but you cannot do the inverse and expect a good day with either.

Un peu ce que je pensais, c'est faisable mais pas idéal.

Je vais me coucher moins niaiseux ce soir.....🤪

Il y a des chargeurs à 20 ampères qui existe comme celui-ci (moins cher) qui serait mieux à mon avis.

https://www.canbat.com/product/12v-20a-charger-ip22-lithium-battery-charger/

Modifié par Octo Claude
  • Like 4
Lien vers le commentaire
Partager sur d’autres sites

Il y a 2 heures, Octo Claude a dit :

Il y a des chargeurs à 20 ampères qui existe comme celui-ci (moins cher) qui serait mieux à mon avis.

https://www.canbat.com/product/12v-20a-charger-ip22-lithium-battery-charger/

C'est plate qu'il ne font pas un chargeur avec 2 bank...Ça va prendre 2 chargeurs...

Lien vers le commentaire
Partager sur d’autres sites

J'ai trouver ceci sur le site de canbat à propos des chargeur Victron :

Synchronized parallel charging Synchronize up to ten battery chargersin a VE.Smart network to make them charge a battery as if they were one large charger. The chargers will synchronize the charge algorithm between them. They will simultaneously switch from one charge state to another, for example from bulk to absorption. Synchronized parallel charging has several interesting advantages: - Redundancy: if one charger stops for whatever reason, the other chargers will continue to operate. - Flexibility: simply add a charger to the network if more current is needed. - Cost: several low power chargers will in general cost less than one high power charger. - Installation: several low power chargers may be easier to fit in a confined space.

Lien vers le commentaire
Partager sur d’autres sites

Je viens de canceller mon chargeur minn kota et je vais me commander 2  Victron energy ip67 12v 25a vu qu'il ne fond pas des 2 banks, en plus ils sont en spécial présentement à 226.98$, les 2 chargeurs vont me coûter moins cher que le minn kota à 2 banks. Avec sa, ça ne prendra pas trop de temps pour charger mes batteries avec la génératrice.

 

@Octo Claude

Je regardais le chargeur que tu as mis plus haut et le problème est que le ip22 n'est pas étanche à la poussière ni à l'eau, le ip67 l'est.

image.thumb.png.f9e76331a1bc840dbf8c3acb43287ba5.png

Modifié par Kingpolaris
  • Like 3
Lien vers le commentaire
Partager sur d’autres sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Invité
Répondre à ce sujet…

×   Vous avez collé du contenu avec mise en forme.   Restaurer la mise en forme

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • En ligne récemment   0 membre est en ligne

    Aucun utilisateur enregistré regarde cette page.




×
×
  • Créer...